One side of my pocket door came down. The inside upper part of the door has a post that goes into the rollers that run on the track. The post came out of the roller. Does anyone have a solution other than breaking the wall to install new hardware? Has anyone had this problem?
Thank you.
One way or another, you have to get at the faulty roller to replace/repair it. However, there is no need to "break the wall"...all you should need to do is remove the top trim on the opening.
If the "post" has slipped out, perhaps just lifting the door up would fix it (back into position/latched). There may be a small latch on the roller needing to be locked.
Oren
--
Look at the jam at the top of the door. With mine one side is held in with a few screws so it can be removed to give access to the rollers. There is a nut that 'locks' the stud in the top of the door to the roller, but others might have a clip of some sort.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required