Been having problems trying to cut 45 degree miters using the JoinTech Smart Miter for over a week now. Using the upper or black scale, the miters are right on, but when I go to the lower red scale they are off by a good bit. When cutting 90 degree pieces, they are also dead on. Am using a Delta Unisaw with a Forrest Woodworker I blade. Have forwarded this problem to the JoinTech tech support folks, but they have been no help at all. Should have noticed this problem some time ago but blamed the poor miter cuts to my lack of attention to squaring the blade etc. If anyone else has had this problem, would greatly appreciate your input.
- posted
18 years ago