Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

woodtrax software

Thinking of buying woodtrax software for cutting out numbers and letters. Has anyone used this program before and is wor...
1 comments posted 21yrs
posted by jtmarshall
1 comments posted 21yrs posted by jtmarshall

right tilt vs. left tilt

I am in the market for a new contractors table saw. Just wanted some pros & cons for right tilt or left tilt. Looking a...
21 comments posted 21yrs
posted by esstewart
21 comments posted 21yrs posted by esstewart

Help with refinish

I have an oak table with some heat spots on the top.. Other than stripping the entire table top,is there any way to remo...
6 comments posted 21yrs
posted by closito
6 comments posted 21yrs posted by closito

Freud FT2000 Router - Guide Bushing

Does anyone know where I can find a guide bushing that will fit this router? The opening in the base is 2 5/8". I am ha...
3 comments posted 21yrs
posted by jbrigan1
3 comments posted 21yrs posted by jbrigan1

Re: Jet & Shop Fox catalogs?

After several years (really) of over analysis, I replaced my tired (15+ yr old) contractor saw with a Grizzly 1023SL ab...
1 comments posted 21yrs
posted by loutent
1 comments posted 21yrs posted by loutent

OT: News reader

What news reader are the aol people using now? Tried a couple but aol doesn't supply a tp for the software. Any recommen...
5 comments posted 21yrs
posted by GeraldR916
5 comments posted 21yrs posted by GeraldR916

Civil War woodworking

Since it's built of wood, I thought I would introduce the group to a project being constructed at the moment here in my...
6 comments posted 21yrs
posted by occupantr
6 comments posted 21yrs posted by occupantr

Canadian Tire Mastercraft Dado Blade

Hi Just wondering if anyone has any experience with the Mastercraft Maximum 8' Dado Blade. It is the V shaped blade. I...
2 comments posted 21yrs
posted by mklegere
2 comments posted 21yrs posted by mklegere

Gloat for somone

16" Delta RJ-45 jointer? $500 bucks? Is that a gloat? I hope no one here is the current high bidder and I'm spoiling yo...
7 comments posted 21yrs
posted by no
7 comments posted 21yrs posted by no

Jointer parts needed

I just bought a Delta Rockwell Crescent 8 inch jointer and need some parts. The serial number is 7118-a and I believe i...
4 comments posted 21yrs
posted by agi733
4 comments posted 21yrs posted by agi733

need help from someone with a lathe in boise

hello, I have a smell project (8 bench dogs cut out of a 1*1*6 that need to have 3 inches at the bottom turned to a 0.7...
2 comments posted 21yrs
posted by cyrille
2 comments posted 21yrs posted by cyrille

TS Final Desicion

Everyone has been very helpful as always. I love this group because you get info from people who use the tools you are...
7 comments posted 21yrs
posted by stickler.iv
7 comments posted 21yrs posted by stickler.iv

Veritas Hinge Boring Jig

I am considering the Veritas Hinge Boring Jig Any comments or suggestions Thanks Scott
1 comments posted 21yrs
posted by swillet
1 comments posted 21yrs posted by swillet