Woodworking Forum

  1. Home
  2. Woodworking Forum
51629 Threads Posts
to

Worth reading in Woodworking Forum

butcher block counter

I'd like to eventually put an 8 foot long (approx) 2-3 foot wide wooden counter in my home. It will likely be supported...
17 comments posted 21yrs
posted by bgold
17 comments posted 21yrs posted by bgold

Forgot my geometry...

I've got a board set at a 45 degree angle, back from a line. How much (percentage) of the length of the board does it t...
53 comments posted 21yrs
posted by David
53 comments posted 21yrs posted by David

Drill Press problem

I just got a 10 years Wilton Bench Drill Press Model 2350. If I grab the top of the spindle that comes out of the pulle...
5 comments posted 21yrs
posted by alexkuzn
5 comments posted 21yrs posted by alexkuzn

WOODEN CANDLE SCONCES

I'm looking for plans for wall sconces that look kind of rustic. Does anyone know of a source? Fangs! Calypso
0 comments posted 21yrs
posted by darcheetah
0 comments posted 21yrs posted by darcheetah

Tip for Roto-Zip saw users

Whenever I've used my Roto-Zip to cut figured patterns in plywood I've always been frustrated with how much splintering...
4 comments posted 21yrs
posted by clent
4 comments posted 21yrs posted by clent

English mortise chisels -- link for neanders

Greetings, I just noticed new English mortise chisels offered by The Museum of Woodworking tools: (watch the wrap.) If...
5 comments posted 21yrs
posted by nospam
5 comments posted 21yrs posted by nospam

Box joint question?

Any recommendations on whether to use a dado blade/tablesaw or a router/table to make box joints. Would one method have...
0 comments posted 21yrs
posted by ronstitt
0 comments posted 21yrs posted by ronstitt

Spraying Lacquer, how difficult?

How difficult is it to spray lacquer with a HVLP conversion spray gun? I have a 60 gallon compressor with a real 230V 3...
9 comments posted 21yrs
posted by belfert
9 comments posted 21yrs posted by belfert

Workshop in Fairfax, VA

Hi everyone living in Fairfax and Loudoun counties, I was wondering if any woodworkers/craftspeople would be interested...
4 comments posted 21yrs
posted by witczak
4 comments posted 21yrs posted by witczak

What applicator for polyurethane?

What should I use to apply polyurethane to some oak hollow core doors? The original doors in the house were sprayed wit...
10 comments posted 21yrs
posted by belfert
10 comments posted 21yrs posted by belfert

need castor info

I plan on building a roll around shop assembly bench simular to the one Mark posted. Question I had was which castors w...
4 comments posted 21yrs
posted by n0y$$
4 comments posted 21yrs posted by n0y$$

XNC controller

hello: My problem is that I use Solid works to design and then I have a biesse machine, my question is how I can manage...
1 comments posted 21yrs
posted by rodrigopradotrueba
1 comments posted 21yrs posted by rodrigopradotrueba

Dimensional lumber load carrying ability

Does anyone know if there is a place on the web that shows the load carrying ability of different sizes of dimensional l...
38 comments posted 21yrs
posted by SC
38 comments posted 21yrs posted by SC