Replacing electric conduit

My garage is about 4 feet from the house (side to side) with a drop of

30" from the cables exit to entrance. There are 2 cables, the alarm and electric lighting cable. On installation these were protected by round plastic conduit. Sadly this was broken by a workman, unnoticed at the time. However it has since degraded further and needs replacing. As it would bee difficult to access the cables ends and disconnect I need a product that I can "slip" over. Any ideas please?
Reply to
Broadback
Loading thread data ...

plastic foam pipe insulation And some UV proof duct tape?

Else the birds will have it for nests

Reply to
The Natural Philosopher

You can get split, round, flexible conduit.:-

formatting link
I think you should be able to buy this at most electrical wholesalers and even at places like B&Q though I can't see it at Screwfix or Toolstation.

Reply to
Chris Green

Many thanks for the info. I have found the same in white as suggested by Chris, now ordered. Cheers

Reply to
Broadback

Does it have to be round? Square conduit is two piece - a U shaped piece that can be fitted behind the wire(s) and a clip on cover.

Reply to
alan_m

The professional electricans who did the original wiring on my house just used a length of yellow gas pipe as conduit (1976) to run power from house, under a path and up into the garage 1 meter away. It's really tough stuff.

Might not comply with 'regs' today.

Reply to
Andrew

Although that tends to be for internal use and IIRC does not have much UV resistance.

Reply to
newshound

If it is only a 4ft length and the cables are not too large split the conduit along its length and spring it open whilst pushing the cables in. A strip of insulating tape should reseal the split.

Richard

Reply to
Tricky Dicky

Chris Green explained :

That would flex, I think the OP needs something a bit more rigid to span the distance. Mini truking might do for what he wants, its rigid, open along one side, with a clip on lid. He might need to chew the rest of the broken conduit off first, with a pair of snips..

Reply to
Harry Bloomfield, Esq.

Too late now, but I'd have looked at Unistrut with a clip-on cover. Gives very good physical protection and support.

Something like

formatting link
SteveW

Reply to
Steve Walker

HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.