I have DT06-6S plug - along with correct pins & wedge lock. I don't have a specific crimp tool for Deutsch connectors (only fitting
here is a link to the plug:
This is ratchet tool I have:
I'd solder it for a one off. Though carefully to avoid solder outside the hole.
In the end I just used the 'indent' crimp on a 'basic' draper 4in1 crimp tool. Concerned solder may prevent the end of plug sealing properly if it 'migrated'
I'd have riisked it with a small narrow bit in a thermostatic solder station iron - but I do see the risk of disaster in a fraction of a second wiith a mm too much solder
Have something to add? Share your thoughts — no account required.
Ask the community — no account required