I've got one of those 'barista' style pressurised coffee machines, and a lovely shot of espresso it makes too. However, the stainless steel filter/strainer widget into which the coffee grounds are placed has very fine holes which are becoming increasingly blocked.
What's the best way to clear them? They're too small for a pin.
On mine IIRC you are supposed to give it a blast with hot water/steam by clipping it in without any coffee and making a dummy cup of coffee. When I try this there is always some coffee colouring in the hot water.
starts with A and ends with R ?
I have the Gaggia one
warm water and a nail brush works for me
Swmbo prefers a tooth brush.... mine I think
regards
Soak overnight in dish-washer tablet and boiling water then rinse well?
Paul DS.
En el artículo , David WE Roberts escribió:
Tried that, ta, and it did clear some of the holes (observed by holding the strainer up to the light).
There's a pic here:
Could try soaking it in a kettle limescale remover?
worried about what is coming out of your tap. A Brita jug is a quick fix and your coffee should be better, as well as your long term health.
If it is copper it'll come off with tomato. Try some tomato ketchup if the vinegar isn't strong enough.
mix 1/2 draino 1/2 water in a glass plate, let the basket set in it for a few hours and be sure to rinse well.
Have something to add? Share your thoughts — no account required.
Ask the community — no account required