7 discussions on HomeOwnersHub about the Delta SD508: what owners asked, what went wrong, and what fixed it.
I got desperate for a scraper today, so grabbed one of my putty knives (Now dammit; no laughing!!!!) and proceeded to flatten the edge on a diamond sharpener. Ran a screwdriver shank over it about half a dozen times, and damn if I couldn't...
I tried my hand at stub tenon joints tonight and ran into an issue. I think may need to buy a stacked dado set. I have an Excalibur twin blade dado set: This is what the stub tenon looks like: I don't know that I want to clean up 100...
According to this post from 2007, the 2 blades listed in the subject line a re (were?) the same blade and also are (were?) decent blades. Does anyone know if this is still true? Stolen without permission from: "The DeWalt DW7657 is a...
What size dado should be used with a 1.5 HP (120V) Delta Profession TableSaw? Is the power adequate for an 8" dado set or should a 6" set be used?Does anyone have experience using an 8" dado set with a 1.5 HP Contractorsaw? What are the...
I just purchased a Freud SD508 8" super dado set for my Deltacontractor's saw.There is a compression washer (cupped) that normally sits between thenut and the blade. However, with this washer installed, I cannot comeclose to fitting the...
My Systimatic Fine dado set has been sharpened for the last time. But it's a set I've never been pleased with for any kind of crosscuts in plywood (especially oak). From what I can gather from the literature, a replacement set can either...