Choices for how to T & G

[Him & Her]

Hi all,

Suggestions needed for best item to buy to tongue and groove a load of timber - various lengths totalling around 300ft.

Small (used) router table?

What else is there, preferably under 75UKP

Cheers,

[Bob Minchin]

Make/buy a feather board to keep the edge of the board flat to the router table. Vital if you timber is a bit twisty and helpful even if not. Bearing guided cutter set will make things easy

My best buy source for quality router bits is Wealden online.

HTH

Bob

[Cash]

Unless it's special job, then why not by the timber already tongued and grooved?

To do that job properly - and safely - for a large run of wood, you would really need a spindle machine rather than a router, due to the cutter shape[s] that are required to cut the tongue (and groove).

Cash

[Him & Her]

Many thanks Bob, particularly for the Wealdon suggestion. Featherboard advice duly noted.

[Him & Her]

Cheers.