6 discussions on HomeOwnersHub about the Jet 10XL: what owners asked, what went wrong, and what fixed it.
I am in the process of purchasing a table saw. It was highly recommended to me to get the 50" fence option. However, this puts the overall width of the saw at about 80". I have limited space, but could make this fit if needed. Is what is...
Greetings!After a few year hiatus (my tour in Iraq, then wife in Iraq, then gradschool), I seem to FINALLY be getting ready to start building somefurniture once again. I am seriously considering buying an Excaliburover-arm blade guide for...
I'm trying to build a laptop writing desk, sometimes called a desktopwriting case. Just a small box with a hinged lid that acts as the writingsurface. I've tried learning dovetails by hand and can get close (well Ilike to think so), but...
Just purchased a 3 phase 5hp Jet JTAS 10XL table saw and now amworking on getting it working in my single phase shop. If anyone hasan opinion on which is best, please let me know. The saw will be usedfor hobby and not business use. ...
When blade is fully down on TS (Jet JTAS 10XL) it rests about 3/16below level of table. That makes it necessary to rout out a spot in azero clearance insert blank so it'll be flat (and level) when thefirst cut is made. Is this clearance...
Picked up an Excalibur Blade Guard at a woodworking show, but now I'mscratching my head how to attach it to the extension table which seems tooflimsy. It's a new style EXBCS Blade Guard with a big bracket that issupposed to be mounted on...