How to get a doorknob apart

On 2/6/2009 12:52 PM SteveBell spake thus:

I know that; that's why I said I wasn't sure if the finish *was* lacquer, because I tried lacquer thinner on it and it didn't seem to do anything, where lacquer would just dissolve. Might be some other kind of varnish.

Try rubbing it with #0000 steel wool. If it at least breaks the glaze it may help a chemical of some kind to finish the job.

KLS wrote in news: snipped-for-privacy@4ax.com:

Thanks for the tip KLS.

Sortta like me with the dentist asking which one hurts and I reply "Pick one".

OK. Try alcohol next to see if it's shellac. If it's varnish or polyurethane, you're stuck with methylene chloride.

An ultrasonic cleaner with heat can do wonders for getting the non-toxic stuff to actually do something. Harbor Freight has a very nice US cleaner with heat and a 2.5L tank that is frequently on sale for ~$70. I have one and it passes the "shred a piece of AL foil" test just fine. The tank is big enough to fit pretty large stuff too.

On 2/6/2009 2:24 PM 1D1OT spake thus:

That's the best advice so far in this entire thread. Thanks.

After applying the white goop (Safest Stripper), a little rubbing with steel wool and the finish came off.

I had forgotten a key ingredient here: elbow grease.

I recalled doing the above years ago with an old, shiny copper spittoon. It had dark tarnish areas under the finish and defied everything else I'd tried. Glad it worked out for you.

As an aside, I occasionally coat the old spittoon (and other copper/brass items) with catsup and let it sit for a while. Wash off with dish detergent and *voila* - bright metal!

On 2/8/2009 7:28 AM 1D1OT spake thus:

I keep vinegar (white variety) around for just that porpoise.

open original image

open original image

replying to David Nebenzahl, Bdms20 wrote: This is from a long time ago, but its the only poat asking this question. So here is the answer. There is a little hole on the interior knob...push in with small alan wrench...hold and start twisting . it will untwist. This will show 4 prongs. Then in one of the 4 prongs sticking out there is a small pin. Remove. Then ....hold outside knob ( making sure its fully tighten)...and the other knob. (Interior) twist like you are opening jar and the prongs will slide out from a catch and the knob will come off.

replying to David Nebenzahl, CGR wrote: How do you get the donor of a part so you can get it off of the door. It's all loose and hanging. Cannot separate the 2 to get it off the door? Please help!