Media for sharper image ionic breeze schematic

sharper image ionic breeze schematic

replying to dpb, Mike Tinker Hacker wrote: I found one of these ionic breeze things on the street with the line cord cut off. Replacing the cord did not make it work. Turns out there is a fuse which blown and the switching transister was shorted due to some kind of electrical disruption. Not being so electronically smart, I removed the complicated control board, top of the unit and the power board between the flyback, tossed them and did a simple wire thing to it snown in ionicAir 1, The red wire was added. and the incapsulated part between the dust collector / Corona wires base. Wound seven turn of highly The ends of the red added wires are connected to the high frequency 24 Khz in a computer power supply where the the 5 volts is derived BEFORE it is rectified at the small transformer inside the AT power supply. A small 12 volt automobile tail lamp is added to the 5 Volt final DC to give the supply sense to load the supply sense to make it produce stronger output. If you seem to be confused by this, You could find a " Hacker Space in your town where you would find someone who knows electronics better than you. IonicAir2 Shows the completed adaption and there is a piece of toilet paper showing the force of the air that is blown from the unit. As far as the schematic, I am pretty much in the saqme boat as you. Since the rather complicated original circuits have been removed and salvaged for parts. The parts that do remain is a flyback that puts out AC ( Very bottom transformer ) and the intermediate block that the corona wires and the dust collector is connected to contains an encapsulated high voltage multiplier that drives the Ionic Air. Mike

formatting link