I've gutted the furnace and put a vent over the intake. the forced air side will be reduced to 6 inches and vented outside.
The blower motor has 3 wires - black, red and white. How do I wire them to a 110 power source?
Looks like you have a two speed motor. Use the black (hot) and white (netural) wires, Tape or wire nut the end of the red wire so it is not hooked to any other wires.
That was it. The red is the high speed, the black low. I might put in a selector switch to control the speed when it needs to be increased. Thanks so much. Peace.
HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.