Already do - because my volume buttons are knackered!
Do that if leaving all day in a less friendly area. Partly to check all windows are fully closed and that the doors are too. When 3 other people just piled out, I don't like making assumptions.
No. Last time I used one, it was on my Maxi at uni. And someone used to still pick the door lock (not hard) and get the lock off and push the car around the car park for a joke! So I never bothered - if students can get the off, I dare say proper crims can too!
Never do (I might check the that the lock buttons are down or recycle from unlocked to locked and alarmed) so can't see me breaking an established habit.
I have a vague recollection that I *might* have used a crook lock on a Reliant three wheeler nearly four decades ago but not more recently than that, so again, not an established habit I'm likely to have any reason to resume at any time in the future.
Actually, that's a habit of younger people rather than us more knowing 'old timers' who know better than to prematurely wear out kitchen mixer tap washers by needless excess compression. I've developed a well established habit of closing such taps with the barest of sufficiency to shut them off (knowing full well, that on mixer taps particularly, there's a considerable latency between properly closing a tap and the cessation of drips from their rather capacious spouts).
If such a tap doesn't seem to have been shut off sufficiently, I'll only apply the gentlest of tweaks to 'fully close' said tap. In this case, "sufficient" is more than enough and any more is just going to needlessly shorten the tap washer renewal maintenance cycle. :-)
I orient the C and H marked domes so that they are in the correct orientation when the tap is adequately turned off. Turning off a tap is akin to placing a lid over a hole - forcing the tap closed is a sign that all is not well - eventually the thread starts to wear.
Are we going to have the game of seeing who is the oldest here so that he/s he can be saying they've been doing these things for 50 years !
Don't watch telly
Never have - I just listen to the clunk of all the locks going over.
What's a Krooklock ? Or am I too old ? >
Ahh - now that's a different story. Just how many times do I go to bed aft er my wife and have to do just that !! But then we use a kitchen mixer tap that is clearly designed for mains pressure hot water and just how often d o either of us leave the hot water running because we can't hear it !!
I'll add in my pet hates of things left in passageways to be tripped over a nd always have to be moved, and ditto for china etc. left right on the edge of worktops and tables just waiting to be knocked to the floor.
You missed the table lamp that is the only acceptable way to light the unoccupied dining room and has to be placed just where a passing elbow can knock it flying.
Otherwise, after nearly 48 years not counting courtship, most of the annoyances have mellowed.
Carefully "fiddling" your way around the seam of the remote you'll eventually workout where the internal clips hide (4 most likely)and which direction to ease them with a fine bladed tool to split the case.
Once you have the remote in half(s) the conductive "rubber" key-pad can be lifted off as a complete sheet and you'll spot the dirty contacts on the PCB. Give them all a wipe with your preferred cleaning solvent (Think I used nail varnish remover last time) and clean the contact side of the rubber buttons while you're at it.
Reassemble and your remote is good as new once more.
OCD now there's a topic that deserves it's very own thread...
1 - Always turning back around once you've left the car and pinging the remote to see the indicators flash (for those of us without auto folding mirrors)
2 - having to re-arrange the dishwasher every day because "they" have put randomly intermingled cutlery in the cutlery drawer or put a small plate between 2 big plates etc.
3 - re-hanging all the washing on the airer with nylons on the bottom rungs and cottons on the top rungs... grouping socks together in pairs and oh so many other things I'd be listing them all night.
I find it odd that I'm OCD to the tiniest degree with stuff like cable runs, clip spacing and stuff like that but my work space whether it be paperwork or tools looks like we've been burgled....
HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here.
All logos and trade names are the property of their respective owners.