Hello all,
I would like to find someone who can do a little bit of metalwork for me. It doesn't need to be local to me. Could anyone recommend someone?
I'm sick of not having an adequate baritone saxophone stand. I have two, one of which is a modern model but useless because the instrument clamp doesn't fit a vintage saxophone and it's too tall, the other is tired and old, works and fits but is not tall enough.
Here is a photo of both of them. They both involve a base with a stiff but movable ball-joint for the shaft, and an height-adjustable attachment with an angled flat plate at the top which goes into a slot in the clamp on the instrument.
This would involve a length of steel stock drilled all the way through to accept the shaft, cut at a steep angle at the end and a flat plate welded to it. Then a hole tapped in the other end to accept the tightening bolt.
Extending the length of the shaft on the base would be handy too.
Is there anyone who could do that for me for a suitable fee if I did a proper drawing?
Michael