Latest threads in Home Repairshow only best voted threads
Subject | Author | Posted | Replies | |
---|---|---|---|---|
|
Stuck Jalousie Windows
I'm trying to fix some jalousie windows in my late mother's house. The operators are no good and I managed to get them off of the frame by breaking off the rusted bolts. But the windows won't open or...
12
|
14 years ago
|
12 | |
|
patch ceiling - peeling paint layer
I hate working on ceiling areas :) Another classic - peeling ceiling paint in a bathroom. We've had this happen before, the paint peels, and then lifts away from the wallboad. In fact - you can slice...
11
|
14 years ago
|
11 | |
|
how to fix curling kitchen tiles
We have the classic problem in the kitchen area. Curling tile square edges/corners... Not sure what to do - The corners are starting to curl up after 20yrs :) Now the chair legs are catching the...
9
|
14 years ago
|
9 | |
|
Foil insulation can be fatal
BBC reports: "The Australian government has ordered a huge safety audit of every home that was fitted with foil insulation as part of a nationwide energy-saving plan. The insulation programme was...
9
|
14 years ago
|
9 | |
|
Fluorescent bulb types...
Awl -- I have a basic understanding of how these tubes work (iirc, they operate off the Franck-Hertz ionization), except for the single pin 8' jobbies, that you don't have to twist to install --...
13
|
14 years ago
|
13 | |
|
OT: For those people using OE to read newsgroups
If you find that your newsreader (OE) doesn't properly quote some messages (especially those from google groups), there is a freeware fix called "oe quotefix". have been using this for over a year...
15
|
14 years ago
|
15 | |
|
Thin drywall tape recommendation?
Looking for thinnest possible drywall tape for repairing cracks in old plaster walls... I would like to keep the feathering as narrow as possible since I am just doing repairs -- and I find the...
23
|
14 years ago
|
23 | |
|
Really dumb electrical question.
I have a Federal Pacific Stablock type panel in my home. I am running in a new dedicated 115V circuit for my whirlpool as part of the bathroom renovations. I have a 220v 20A GFI stcu in the panel...
26
|
14 years ago
|
26 | |
|
Frigidaire Double Wall Oven
I have an ancient Frigidaire double wall oven Model #RBE-97K. The upper will no longer heat at all. If I turn the dial the red light doesn't even come on(no heat from either Bake or Broil). However,...
1
|
14 years ago
|
1 | |
|
HEPA filter for furnace floor vent?
Has anyone seen pleated HEPA filter that fit into floor register vent? I froogled but no luck. Maybe nobody makes such product. The closest I found are sheets filters like this: I need is HEPA that...
5
|
14 years ago
|
5 | |
|
Refrigerator repair
I have a Frigidaire side x side refrigerator. The dispenser on the door drips from the water dispenser. What can cause this ? Also the ice cubes come out at crushed ice,not cubes.
7
|
14 years ago
|
7 | |
|
electric baseboard versus in-floor heating
My wife and I are considering remodeling our kitchen (12'x15' area). Currently, the kitchen is heated by a 6' long 220V baseboard heater with a thermostat on the wall. I'm thinking of pulling out the...
10
|
14 years ago
|
10 | |
|
Cheapest way to replace thermostat bulb locked at 65°F with more intelligence?
It doesn't "plug in", it has screw terminals. Make a note of what color wire goes on which terminal (they are lettered) and put them on the same terminals on the new thermostat.
11
|
14 years ago
|
11 | |
|
Cooper pipe bending limits
So I'm installing 1/2 and 3/4 copper water pipe, city water, ~60psi. Question - how much can you safely bend the pipe without risk of future failure?
74
|
14 years ago
|
74 | |
|
running fluorescent light w/ one tube dead?
just curious if there are any long-term negative consequences to using a fluorescent fixture w/ a dead tube... specific application is my desk light, it's a (very old) Dazor "floating fixture" deal...
9
|
14 years ago
|
9 |