Latest threads in HVAC Discussionsshow only best voted threads
Subject | Author | Posted | Replies | |
---|---|---|---|---|
|
Will it work?
I have a 16' X 16' single floor addition off my kitchen space. Currently we have a wood stove for heat but it really over heats the space. Just off the end of the kitchen is a 10 X 20 room that had...
5
|
13 years ago
|
5 | |
|
Worlds biggest thermostat ?
http://graphics8.nytimes.com/images/2010/10/11/nyregion/11Appraisal1-cityroom/11Appraisal1-cityroom-blogSpan.jpg
2
|
13 years ago
|
2 | |
|
Trane XL80 Controller Fail
I have a Trane XL80 that tries to heat but sometimes fails with a call for heat, but no flame detected. It is not the flame detector as the flame is not there. It turns on the gas, but the ignitor...
5
|
13 years ago
|
5 | |
|
ductwork, mitered corners, what can be done to help the air movement!!!
I have a two story home, with 6 x 18 steel ducts used as a main supply trunk. The outlet to each room is off of this main trunk. I have really poor air flow in all the rooms, even with all vents open,...
8
|
13 years ago
|
8 | |
|
open flood gates??
Seems like somebody opened the flood gates again.... I'm booked up for the next week and a half with system replacements and seasonal service. Seems like the more seasonal service calls I do, the more...
33
|
13 years ago
|
33 | |
|
Tempstar TX5300 heat pump
My electric Tempstar tx5300 defrosts even when it is not real cold? Does it have a thermostat or timed defrost? Can it be changed so it defrosts less frquently?? T4H336GKA200
1
|
13 years ago
|
1 | |
|
Heater Defrost Balance Point
Am I correct that the 'Heater Defrost Balance Point' is the setting for calling for Aux heat when the outdoor temperature hits a certain point
33
|
13 years ago
|
33 | |
|
WOW been gone awile and nothing has changed.
Stormin posting the question about filter estimate!!!!!! Geez ! Why do you open yourself up to such ridicule? You must know by now asking such an elementary question is going to get you negative...
3
|
13 years ago
|
3 | |
|
Wanted ASAP: Honeywell Q327A pilot burner assembly
Boiler information; Manufacturer: Burnham Boiler #: P-204-W Serial #: 17036211 Q327A AB 8241 is what I see stamped on the existing pilot burner assembly. However, the manual for the boiler lists it as...
2
|
13 years ago
|
2 | |
|
Roof top filter changes
I've been asked to provide a quote, to change air filter for 8 roof top units. In different cities. Farthest one is about two hours drive. All of them are at malls. Not sure which ones have roof...
13
|
13 years ago
|
13 | |
|
Can't adjust the Pilot light in my Gas Stove? adj screw.
My pilot light flame has gotten too big, it does past the two sensors. I found the adjustment screw on the honeywell valve, but the flame does not respond to the adjustment. I tried unscrewing it all...
11
|
13 years ago
|
11 | |
|
Wanted: Honeywell nozzle Q327A AB 8241
Can anyone help here? This Q327A AB 8241 nozzle is for a Burnham 204 boiler/furnace. Equivalents may work, however, the only certainty so far is that this one, that looks similar, will not;
1
|
13 years ago
|
1 | |
|
Equipment and Products
AC Repair Orlando is a trusted firm in residential and commercial air conditioner maintenance service provider in Orlando, FL. The company provides equipment and products that are commended by the Air...
1
|
13 years ago
|
1 | |
|
Using 'comfort link" thermostat to lockout a stage.
Hello Have a 2 stage HP (Trane XL20i) controlled by a TCONT900 ThermStat (appears to be a Honeywell VisionPRO) using 3 wire data link. Would like to be able to lock-out 2stage heat on HP (at times). ....
—
|
13 years ago
|
— | |
|
DIY furnace replacement
What are the warranty problems that one will run into if you so a DIY on a replacement of your furnace? I've seen some mfrs (Goodman for one) that no longer accept non-professional installations for...
7
|
13 years ago
|
7 |