OK folks, about well water...

Just closed on a small cottage adjacent to our property up in the Mountains...

First weekend there and everything is dandy. Turn on the hot water heater, the pump, raise the thermostats and light a fire in fireplace... Damn. The hot water is basically murky and smells of sulfur, the cold water doesn't smell as much and is less murky but still not anything one would drink. Maybe it's just inactivity so lets run it and let it drain the system and the hot water tank. Maybe fill up the tub, drain and start again. So I fill the tub and by the time the water gets to the midway point I can't see the bottom anymore. Oh boy, we've got a real problem.

Anyhow, after doing that a couple times, the sulfur smell is basically gone and the color is better. The cold water is much much better but still a little bit murky.

End of the weekend and things have improved but still not drinkable, barely usable to wash with.

QUESTION: What experience do/have some of you had with this situation and what did you do about it?

Flush the well? Install special filters? Kill the whole system and dig a new well somewhere else (not really an option)?

Reply to
Pierre Levesque
Loading thread data ...

"Pierre Levesque"> wrote

Get the water tested, to see what you're working with. Have it tested by someone that is familiar with the water in that specific area. I'd avoid messing with the well directly if at all possible cause that sounds expensive. Here, wells cost $100 a foot, thats why nobody has one, everybody is on muninciple. (I'd prefer a well myself, I like to control my own destiny and thats what I've had exclusively since 1988) Next, consider getting a softener and a whole house filter. (they cost $500 and up depending) I'm also wondering if the interior of the water heater has been permanently stained/contaminated, if such a thing is possible. Its hard to tell whats going on if the water has not been tested. Sulpher can be disipated with a standard aerator system, which may be what you have right now. Anyway, get the test and post the results here.

Reply to
Don

When returning, stagnant water should be flushed from the pressure tank and the pump until it runs as clear as possible and then flush all the cold water fixtures. Then run hot water until it is as clear as possible; draining and flushing the tank will help and speed the process.

If the odor is not caused by naturally occurring H2S gas it will be caused by bacteria. If the cold water does not have the odor and hot does, bacteria are responsible. Raising the water heater temp to 140f will kill all bacteria including Legionaire.

The dirt can be from iron, manganese and invisible sediment, which all waters contain. If the water comes out of the well dirty, then before running water into the building, run water outside as close to the well as possible until it clears.

You should have a water test done for iron, manganese, Coliform bacteria, nitrates/nitrites and hardness. If you have Coliform, and pretreat the water you could use a UV light. Pretreatment would be for iron, hardness, turbidity and H2S. You may be able to use a softener for everything (listed) except H2S which goes right through a softener.

Shocking a well can cause problems with the water quality, pump, power cable if a submersible pump, drop pipe if galvanized and cause more bacteria related problems in the well which can lead to a reduced recovery/production rate by causing encrustations that chlorine can not penetrate. Bacteria will live in/under the encrustations, so the problem will still exist albeit it may be less of a problem.

Then you'd need well rehabilitation/cleaning. Or a new well, and they do not come with any guarantee of water quality, so you could end up with better, the same or worse water quality and have a lot less money for water treatment equipment. So it's always better to treat than to drill a new well unless the present well is not producing the volume needed for the building.

I have 20 years experience in water treatment and I also have done well pump work for most of that time. I've also answered questions like this in many newsgroups and on web site forums for the last ten years.

Gary Quality Water Associates

Reply to
Gary Slusser

HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.