VersaFeed stock feeder

[Robatoy]

I see that The General and Delta offer the same stock feeder. It is low cost and looks like it should work. I cut a lot of strips of solid surface, very boring work, and whenever I do a lot, my hands feel like they want to drop off. Plus , there is always a snipe when I change hands.. and over a 12-foot length. I do that often.

Soooo.. here's hoping--> any of you fine gents use one of those VersaFeeder/Brute jobbies?

I know and have used the Delta's bigger brother. It is nice, (like the one one of our contributors here uses on a table router) but..I'm trying to save a few bucks.

Thanks in advance.

0¿0

Rob

[Eddie Munster]

I have one and it does do the job. I use it on my shaper. If I were to do it over I would get a larger one but it is twice as much money. It moves the wood well and the wheels are grippy.

John

Robatoy wrote: