- Bazooka Joe JERUSALEM RIDGE
- posted
19 years ago
- Bazooka Joe JERUSALEM RIDGE
^^^^^^^^^^
Where does one find such a beast? The guy at the BORG said that straight tubafores were all made of unobtainium :)
Rob
Tue, Jul 27, 2004, 8:43pm snipped-for-privacy@amateurtermite.com (Rob=A0Walters) says: Where does one find such a beast? The guy at the BORG said that straight tubafores were all made of unobtainium :)
Try shopping for wood at a real lumber place.
JOAT Expensive tennis shoes won't cure a sore toe.
- Bazooka Joe JERUSALEM RIDGE
Well . . . right. But if you want really straight circular saw cuts get one of the aluminum cutting guides on the market (you can joint the 2x4 to get a straight edge but it probably won't be straight for long). Take care setting up and running the saw and you'll be amazed how straight you can get it.
Tim
Try shopping for wood at a real lumber place.
JOAT Expensive tennis shoes won't cure a sore toe.
- Bazooka Joe JERUSALEM RIDGE
MDF comes quite straight on factory edges.
I tried this after reading it somewhere, and I like it a lot: rip off a strip of MDF 3" or so wide. Cut some 1/4" plywood 12" wide. Nail and glue the strip onto the plywood, face-to-face, with one set of edges coplanar. Do this so that the factory edge from the MDF is on the inside of the newly fabricated guide.
Then, using the MDF as a guide, rip the plywood with your circular saw. Make sure the wide side of your saw shoe is against the MDF, not the narrow side. When you're done, you have a saw guid thate allows you to cut without measuring to offset for the saw shoe. Just mark your work, and clamp the guide down so the edge of the plywood is on the cut line. The blade will go right there.
-Mike
HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.