PING: No-drip edge router bit request.

I don't recall the OP, but here's the solution you're after. You probably have the gig completed by now, but here's a suggestion for any future challenges.

formatting link
you use it, then finish with a regular small round-over router bit.

r
Reply to
Robatoy
Loading thread data ...

There's also this one, which leaves a rounded edge.

formatting link

Reply to
Chris Friesen

*S*...yabbut... the challenge at hand was to continue the no-drip edge into the inside corner of an L-shaped counter top...
Reply to
Robatoy

HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.