Jointer Question

Page 2 of 2  


This is probably going to sound patronizing, but try to raise it so that the piece doesn't snipe, but not so high that the forward edge of a freshly jointed piece drags over or pauses at the outfeed. If the outfeed's too high you get taper.
As I said, consistent error goes to the machine. None of us are good enough to get consistent error.
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload
Gerald Lasco wrote:

Easier to simply raise the outfeed table a smidge and test...when it goes away, you've got it...
Add pictures here
<% if( /^image/.test(type) ){ %>
<% } %>
<%-name%>
Add image file
Upload

HomeOwnersHub.com is a website for homeowners and building and maintenance pros. It is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.