Help wiring original magswitch on a Grizzly G-1012 BSaw

I am in need of some help wiring up the original magswitch on a Grizzly

G-1012 band saw.

The story is that when checking out this new-condition, second-hand saw it kept tripping the circuit. For some reason, at some point, I figured the problem was in the switch. After trying the switch from the duct collector, I discovered that the 240 rewire on the motor was done wrong (hence the new condition). So, I eventually put the switch back on the dust collector and need to get the original saw magswitch back on so I can finally get some resawing done.

Oh, yes, the big mistake was not writing down the simple wiring config and not getting the thing back on soon enough to remember.

I've talked to Gizz tech support and googled around but can not get clear instruction on the easy wiring of this complex looking switch.

Could someone with that saw or another Grizz product with that switch please open their switch and give me the ABCs of getting rewired ?

This is the switch:

formatting link
is the saw:
formatting link
is not my wife nor my tool belt:
formatting link
Bart

Reply to
bfay
Loading thread data ...

Reply to
Art Greenberg

HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.