Is anyone using the 34-928 miter gage from Delta?
They call it the deluxe miter gage and I believe it's shipping with
some of the upper end Delta saws.
The gage seems to have a thumb lever so that you can move from slot to
slot for the pre-set angles. My question is, is there something that
holds the lever out of the way when you need to tighten the gage at
angles other than those that have slots?
For instance there is a slot at 22 1/2 but if I need 23 do I have told
down on the lever while I turn the gage and tighten it down? Or, is
there a position where the thumb lever is not active at all?