I'm fitting a modern style tap (that has two screw in copper 15mm pipes for the water supply, so you can't fit a usual flexible connector that has a tap connector at one end, can you get flexible pipe with a "normal" 15mmm compression fittinig on both ends, or an adaptor? Its a really fiddly location behins a double sink and it would be pretty hard to work without some flexibility.
Following up to Mike....
forget it! They were just out of stock where i looked
Better than that - you can get flexible tails which screw into the base of the tap in place of the supplied rigid tails, and which have push-fit or compression connectors on the other end.
There are at least two thread sizes - M10 and M12 - used for connecting tails to monobloc taps, so you need to determine which size you have.
Then go to Screwfix.com and look at item 27936, 91351, 99193 or 84084.
Following up to Roger Mills
brilliant!
Yes. Flexible tap tails.
You need to know if they are 10 or 12mm. Alan.
HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.