D-I-Y installation of fire sprinklers

Why can't I install fire sprinklers myself? Seems easy enough mains water already ready in the attic. A bit of push fit piping from B&Q Hole in ceiling one head = one sprinkler system

Reply to
zaax
Loading thread data ...

How are you going to activate them? If you choose the glass bubble type, then how often are you going to test them to make sure they'll work when they need to? They're also not that suitable for smouldering materials, which, in a residential environment, is not a good thing.

Are you sure there is no other way to stop the water than at the hydrant point in the street? Your mains supply is not one to be relied upon in an emergency situation, and that's why an uninterruptible water supply is needed for this type of installation.

How hot does it get in your house?

Reply to
BigWallop

who says you can't?

Reply to
Steve Walker

The thouught that the piping must be able to stand the teat of the fire, else it will break, and the water will come out in the wrong place. But a pipe full of water is a bugger to solder, so maybe you just need to not use rubber push fit seals and plastic pipes ....

You need to consider accidents, I guess an accident with the sprinkler is more likley than a fire, which is what puts me off.

Rick

Reply to
Rick

Because your Insurers will require an LPC registered company to design and install them, to make sure in the case of a fire that the loss or damage through fire is not offset by the amount of water damage. Otherwise your insurance could be null and void.

The installation would need to be properly calculated, to make sure the town main has sufficient water flow at a given pressure and pipework sizes are sufficient, dependant upon the hazard rating set by the insurers.

Reply to
Kaiser

There may be a number of other issues too (amongst many):

The law may say that X is not compulsory. However, if you do use X that you then take on certain obligations.

For example, it used to be the case (and it may still be the case) that an older vehicle did not require seat belts. However, if you fitted seat belts to that vehicle, then you were required by the law to wear them.

You may find that installing fire safety equipment may place certain requirements upon you in terms of planning regulations, fire safety regulations and other regulations.

It is worth checking with the local fire service and the council planning department.

If you are in a rented property, then you may find that you need the landlord's consent.

Graham

Reply to
graham

HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.