Hi All. I need a fine bit for my ancient Antex X25, but all I see available are XS bits. Does anyone know if the XS bits are going to fit my X25?
Thanks.
Hi All. I need a fine bit for my ancient Antex X25, but all I see available are XS bits. Does anyone know if the XS bits are going to fit my X25?
Thanks.
What is the element shaft diameter? I'm using quite old Antex 50w 24v types, and on that it's 4.5mm. No problem getting bits for that - although the design may not be identical to the original.
Strangely, I noticed my Local Maplin had quite a good range on display, so you might take it there and see if you can get one to fit. I think there were only two shaft sizes in common use for their smaller irons.
4.5mm looks about right.
Yup pretty sure they are the same. My TCS also takes the same bits as my X25
HomeOwnersHub website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.