I sprayed some tools with wd-40 since they were rusted. After reading
some posts here, it appears that vinegar is pretty good with rusty tools.
Is it ok to put the tools that were sprayed with WD-40 into vinegar+salt
in a plastic container? Or am i going to get a harmful chemical reaction?
Using M2, Opera's revolutionary e-mail client: http://www.opera.com/m2 /
Tthere will be no problem with a reaction between the mixture and
WD-40 as far as a reaction. However, WD-40 does leave a light oily
residue. This residue might restrict the action of the salt-vinegar
mixture. You should remove as much of the the WD-40 from the rusted
Radio Control Aircraft/Paintball Physics/Paintball for 40+
ummm..take a piece of trawl netting large enough to hold your
tools. Hang made up toolbag over the side of slowly moving vessel
(2-4knots) at sea. About .5 of an hour frees up most 'seized'
tools and softens the corrosion on all.
Treat with fresh water and scale remover afterwards -
HomeOwnersHub.com is a website for homeowners and building and maintenance pros. It is not affiliated with any of the manufacturers or service providers discussed here.
All logos and trade names are the property of their respective owners.