I had my wood (white oak) floors refinished in Nov 03.
FYI: 50 year old house in So. Cal.
A section of the floor approx 6' x 5' needed to be removed and
replaced due to water damage. The 6' x 5' section is in a corner in my
dining room next to my kitchen. After the repair the floor looked
good, the slats were nice and snug to each other.
Now 2 months later there are noticeable gaps between several of the
Can someone tell me why this would happen?
I'm getting ready to call the company that did the job but I'd like to
be informed before I do.
Did the guy not secure each board to the sub-floor, only the last
board next to the wall?
Bad wood slats?
Is there any other info I can provide that will help determine what
caused this to happen?
I appreciate any helpful info.