Blade Direction

[J.F. Kirkland III]

On a Miter saw, which way is the blade or teeth supposed to go. Label on the right or left ?

[Rich256]

Just look at what direction the motor turns.

[m Ransley]

What does the label have to do with it unless you specify Brand, even then TROLZLL

[Colbyt]

Down, into the wood below.

[bamboo]

When you unscrew the arbor nut it is turning in the same direction that the blade would turn when cutting. Otherwise it would come loose in use.

Daily Grind Sharpening Service

[Phisherman]

A miter saw or chop saw should have the closest teeth (to the operator) in the down direction.

[George E. Cawthon]

Ignore the label (are all blades labeled on the same side?). The teeth cut down into the board so that the board is pushed against the fence.