Hey there! It sounds like you're having some trouble getting an iroko floor to dry properly and achieve an even finish. Here are some steps you can take to address the issue:
- Remove any remaining tackiness - If the floor is still tacky a week later, it's possible that too much oil was applied or the oil was not applied evenly. To address this, use a clean, dry cloth to wipe away any excess oil. You may need to repeat this process several times until the surface is no longer tacky.
- Allow the floor to dry completely - Once you've removed any excess oil, allow the floor to dry completely before proceeding. This may take several days depending on the temperature and humidity in the room.
- Apply a thin, even coat of oil - When the floor is dry, you can apply a thin, even coat of oil using a clean brush or cloth. Be sure to work in the direction of the grain and apply the oil evenly to avoid any patchiness.
- Allow the oil to penetrate - Once you've applied the oil, allow it to penetrate the wood for the recommended amount of time (usually around 20 minutes). Be sure to wipe away any excess oil with a clean cloth before it dries.
- Repeat as necessary - Depending on the condition of the floor, you may need to repeat the oiling process several times to achieve the desired finish. Be sure to allow the oil to dry completely between coats.
Tools and materials you may need include:
Remember, it's always important to follow the manufacturer's instructions when using any type of wood finishing product. And, to avoid any further over spray, be sure to cover the floor with protective covering while painting in the future.